Aeon Labs Multisensor 6 in 1 configuration

I’ve recently configured two MultiSensor 6’s and everything works just fine. That is except for the fact that the LED on the device bothers my wife when it briefly turns on in the middle. I’ve turned it off (option 1) in Habadmin, but the LED still turns on every time something triggers the PIR.

Any suggestions as to where to look?


Should work (just did it myself) at least with current firmware versions of the sensor.
Check zwave debug logs to see if there’s anything wron when you try setting that parameter.
Upgrade to latest zwave binding (to be included in the snapshot versions) or even try the development binding.


It would also take a while for the changes to come through.
I find myself changing the parameters multiple times before it actually works.