The motion sensor and tamper functions on the Multisensor do not work. The temperature, luminance, UV, humidity and battery functions all appear to be reporting as expected. I’m running OH2 on RPi 3 with a Razberry zwave interface board. On top of Raspbian Linux. Looking at events.log, the binary_…

I should add that the same error exists for your Zipato bulb, so I think it’s highly likely that the key changed and therefore you can’t communicate with any secure device that was included with the old key… There’s no way back from this if you don’t have the key used for inclusion.

[image] chris: Which version did you change to? Is this the master binding (installed through PaperUI) or is it the development version (ie the one with security). Good question, @chris , and I have to say I wasnt 100% sure myself. However a simple test of checking all bindings removied using …

Good afternoon @chris , now that the version of the zwave binding confirmed as the SNAPSHOT version, onto the next steps… Looking at the debug logs, it looks as if the motion and tamper alarms are now being seen by the zwave handler however they are not normally appearing in either /var/log/openhab2…

@RichardK , did you do a secure inclusion or not? If you wave your hand just in front of the sensor, do you see a green light or a blue light flashing shortly? (Note, with the default settings, you should wait a few minutes to try again. There is a kind of delay built in, although you could reconfig…

[image] tonus: is in the stable 2.3.0 security built in? No - security is not included in 2.3 stable. [image] tonus: And what about 2.4.0 ? What do you mean? 2.4 should be built automatically as a snapshot now and should be available if you use the 2.4 snapshot runtime.

Thanks @chris for the fast reaction! :+1: I meant: Is security included in 2.4.0? (the version I downloaded at https://openhab.ci.cloudbees.com/job/openHAB2-Bundles/lastStableBuild/org.openhab.binding%24org.openhab.binding.zwave/artifact/org.openhab.binding/org.openhab.binding.zwave/2.4.0-SNAPSHOT…

[image] tonus: I meant: Is security included in 2.4.0? No - not quite yet… [image] tonus: If not, what is the link to the development branch with the security built in? If you go to the following link, the latest binding is always available from the link at the top of the thread -: …

Hi @tonus My Aeotec Multisensor 6 is included insecurely, I get a green flash from the LED when it senses motion. Like you, I find that the device works pretty well (temperature, humidity, light level etc) once it has been successfully included however there are still no notifications for motion o…

[image] RichardK: there are still no notifications for motion or tamper. Is that using the development binding? Please provide a debug log and I’ll have a look at what’s up.

No @chris , its still using the 2.2 production version. So the debug example I provided previously would still be relevant and I would expect the results to be unchanged. I am intending to move to 2.3 shortly, I’ll retest at that point and provide updates. Cheers, Richard

Ok, this is quite old then. If you plan to move, I would strongly suggest to use the development version. You can find this by searching for Zwave security. If you wait a few weeks hopefully it will be merged into 2.4 snapshot…

Aeotec Multisensor 6 - motion sensor not working

Add-ons Bindings

chris (Chris Jackson) June 1, 2018, 4:43pm 24

No - not quite yet…

If you go to the following link, the latest binding is always available from the link at the top of the thread -:

Hopefully in the next few weeks I will have this merged into 2.4 master.