Alexa rollershutter commands swapped

[Neithari (Manuel Etspüler)]

Hey all,

I am a new Member, lurking the Enocean thread for about 2 years now.

I’ve finally made my first openHAB install and it’s working great so far.
My only problem is Alexa is swapping my commands for my rollershutters. So “Alexa open bedroom blinds” will close them and vice versa.

The Amazon Alexa Metadata is set to “Blind” according to the documentation.
And as far as I understand the documentation the “Blind” lable is defined as

Rollershutter Blind "Blind" {alexa="RangeController.rangeValue" [category="INTERIOR_BLIND", friendlyNames="@Setting.Opening", supportedRange="0:100:10", unitOfMeasure="Percent", actionMappings="Close=0,Open=100,Lower=(-10),Raise=(+10)", stateMappings="Closed=0,Open=1:100"]}

However I cannot find a config file that has this or any lable configuration.

I am on OH3 latest and only used the webinterface so far.

I hope that someone can point me on the right direction.

Neithari

[denominator (James Bowler)]

Alexa V3 skill - Blind Control Inverted Values

Hey All, I am trying to implement the integration between Openahb and Alexa V3 Metadata. All is working normally and smoothly except the RollerShutter item where the Open and Close commands send inversed values to Openhab. In another way when I say Alexa “Open Kitchen Blind” Openhab receives the 100 value which shows that the Blind is Closed on the app. And when we send a command “Close Kitchen Blind” Openhab receives the 0 Value which shows the Blind is Open. Here is the Item that I use for …

[Neithari (Manuel Etspüler)]

Thank you for that link. Not sure why I didn’t find that thread myself.
I think the last post is all I need there is a example where I put the configuration.

Neithari