Bentel security absoluta

[radeon1979]

Hi, is possible to support Bentel security absoluta???
Bentel is a european division of Dsc (Already supported).

[Bruce_Osborne]

If you write it they will come.

Does this thread help?

DSC Alarm

Just a quick update on my progress. I’m still bench testing the panel at this stage as I haven’t had time to install it. I was keen to see the delay betwern the DSC zone triggering and an esp8266 receiving a message on an mqtt topic. The esp8266 is simulating a relay or zwave lighting controller. I’m pleased to say that there is at most a 2 second delay. This confirms that the passive infrared motion sensor connected to the DSC panel will make a suitable room occupancy detector.

[giorginus80 (Giorgio)]

Bentel absoluta uses comet and only with single connection so if for example u use app u can’t use binding. For example to know the current status through api absolutau should poll the service and if u poll the service and u use the app one of them can’t be used.
The best solution is to put inside the bentel absoluta a switch that tell u the status (I used a fibaro binary zwave sensor) and u can use relay to switch one the zones OR as I did to switch on the zones I did a java batch (calling the api bentel) that I call with a command on openhab. I did a binding too, but it’s not the best way because as I said a binding should “refresh” with some kind of polling the status of the bentel and this cause that the android/ios app not working

[radeon1979]

Hello giorginus, is possible to have more info?
please reply on PM. I am italian.
Thanks

[madmicio (Maurizio)]

Ciao Giorgio,
where did you find the API for bentel?
please reply on PM. I’m Italian too

[r8plicant (Ste)]

@giorginus80, also interested in Bentel APIs, I’ve never been able to find them!
Grazie in anticipo, Ste

[Acondo]

Buongiorno Giorgio, su quale piedinatura hai inserito lo SmartImplant? Grazie.

hi Giorgio, on which contacts did you connect the SmartImplant? Thanks.

[Bruce_Osborne]

Sorry, this is an English language forum.

[giorginus80 (Giorgio)]

@r8plicant

@giorginus80, also interested in Bentel APIs, I’ve never been able to find them!

I used the output pin and configured with bentel absoluta programming interface throug ethernet