Hi all,
as I didn’t found the issue in the binding I started first, I started just another test binding and there state update was working. Thus I created another Danfoss binding called DanfossHRV and now implementing step by step very carefully channel by channel and so far it works with 5 channels updated every 10 seconds:
- mode get and set (Dropdown)
- level in manual mode get and set (Dimmer)
- Humidity
- Battery Level of the Air Dial
- Current DateTime as set in the HRV
Other channels only seem to be a diligent but routine piece of work.
Missing in the new binding is so far the discovery, but I think I add this soon. This also requires to use configuration properties. When this works we are near to a working binding.
Regards,
Ralf