Date change logging

Setup, Configuration and Use Beginners
1

openhabian snapshot

My log file shows this:

2018-10-02 12:30:52.022 [vent.ItemStateChangedEvent] - Date changed from 2018-10-02T12:29:51.995-0400 to 2018-10-02T12:30:52.004-0400
2018-10-02 12:31:52.040 [vent.ItemStateChangedEvent] - Date changed from 2018-10-02T12:30:52.004-0400 to 2018-10-02T12:31:52.021-0400

Note that it is logged every minute and the source of the log is clipped.

I don’t seem to have anything set to update every minute, so I’m curious if this is from a binding I’m using.
(I have: NTP, ZWAVE, ASTRO, NETWORK)

And, is there a way to get the log to not clip the logging source?

2

Should be then ntp binding, as this is the binding which will update date and time at the event bus (if linked to an datetime item)

3

Hmm…I changed the refresh interval from 60 to 600, hit save. A pop-up said it saved.

Still updating every 60 seconds.

Went back to look at it again and it was still showing 60.

Log just showed an http put request., no error