Have been fighting an issue with one of my many Z-Wave Dimmer Switches not detecting scene changes. This is the only one I have of this particular older model. The Thing’s Dimmer Channel works fine, however the Scene_Number Channel simply never gets an update when double/triple tapping the physical switch; no log entries appear either.
As all of my other makes/models that provide a Scene_Number Channel are working great, is this possibly a problem with the Z-Wave Database entry for the 14295? I’m at a loss as to how to diagnose further short of factory resetting it (again); would appreciate any advice.
Without unfiltered debug logs saying what is happening only your system has the answer. Even is somebody else had similar symptoms, they could very well have had a different underlying issue.
Thanks @Bruce_Osborne - this is the first Z-Wave problem I faced after setting up 30+ Z-Wave devices spanning many OH channels. I will certainly dig deeper and see if the raw DEBUG logging shows anything of interest. I had actually previously posted the (only semi-filtered) raw logs but then redacted them here after I realized there was nothing different in them while comparing the effected nodes logs to other working Z-Wave nodes. Didn’t want to waste anyone’s time with studying a slew of redundant messages.
I understand and respect this is a complex protocol; beyond any errors/warnings captured at a node level requests/responses, can you provide some suggestions as to other types of messages (i.e. keywords) to look out for? I had already dug in deep looking for anything specifically abnormal related to this Node ID (i.e. error/warn, at the DEBUG log level), but nothing stood out.
Note also I have done a TON of Z-Wave Network health testing using other tools like Simplicity Studio/Zensys Tools; they always comes back GOOD. It doesn’t seem related to my network setup but just this particular device & its Scene_Number channel only.