How can i simulate the communication between the OpenHab mobile UI and BeagleBone Black board without using a real sensors?

1

Hello everyone,

I’ve configure my BeagleBone board with OpenHab and my mobile user interface.

I want to know, can i simulate the communication with virtual sensors ?

Thank you,

2

Yes, install the demo, you’ll find it here.

3

Hello Sihui, I’ve do it. i want to see the communication without real sensors.

Can you give me video ?

Thanks

4

Not from the demo, but maybe this helps you a little bit …

5

Sihui,

I want to say that i was configure my board and my UI application. I’ve tested the demo too.

I want know if can i see simulation when using the UI without real sensor ?

I sow videos, but i found that they used a real sensors like ( lump and others … ), i want just make simulation to verifay the connectivity because i dont have devices.

Thank

6

[quote=“arbi_mahdi, post:5, topic:4512, full:true”]
i want just make simulation to verifay the connectivity because i dont have devices. [/quote]

If you don’t have any devices you cannot simulate connectivity.
I never used the demo, but try to switch some items on and off and take a look at openhab.log if there is any activity (but there will be never connectivity).

Good luck.