KNX installation wiring


I’ve been building my home KNX network using the basic terminal blocks and this, of course, works well but is a bit pain in the butt to debug when disconnecting lines, etc.

I’ve recently tried Wago Winsta KNX and I love everything about it (except the price).

Was curious - what are you using to wire your KNX install?

Just found this thread. I’ve been wondering the same thing. So far I’ve used Wago lever connectors in Wago junction boxes.

But yes, it’s not easy to disconnect lines. Thankfully I’ve not had to do this much so far. The Winsta connectors are incredibly expensive last time I checked.