KNX OpenHab Binding - Device not recognised

Add-ons Bindings
,
1

Dear community!

can someone help me with configuring the KNX binding?

I ran into following problem in the PaperUI when trying to connect one KNX device:

KnxOHtest
KnxOHtest1115×592 99.9 KB

KNX IP Gateway works fine - shows to be online

KNX Device Parameters:
Bridge selection: KNX/IP Gateway
Address: 0.0.1

Channel: Switch
Address: 0/0/1

Kind regards,
Kale

2

Do you have access to your KNX project (ETS)? Are these PA addresses valid, GA’s also?
Are you sure you are trying to communicate with devices on the KNX backbone?