Mqtt Binding: step property nor working properly for transformations

[extasic]

@gforce2010

I’m also using Zigbee2MQTT and had it setup the exact same way you did.

Good to know I’m neither alone nor just too stupid to set this up

@gforce2010

In the end I installed the legacy MQTT V1 binding so I could use some more complex Javascript transformations that could convert the 0-100 slider to 0-255 rounding all the numbers to remove the decimal point.

I’m not too deep into this yet. So can you please tell me what the MQTT v1 Binding allows in terms of transformation that can’t be realized with transformationPatternOut and transformationPatternOut?