# New binding - Rego 6xx based heat pumps

**URL:** <https://community.openhab.org/t/new-binding-rego-6xx-based-heat-pumps/17219>\
**Category:** Bindings\
**Created:** [November 24, 2016, 8:36pm UTC](https://community.openhab.org/t/new-binding-rego-6xx-based-heat-pumps/17219 "2016-11-24T20:36:47Z")\
**Posts on this page:** 1\
**Showing post:** 210

<div class="post-metadata">

**Author:** ![crnjan](https://community.openhab.org/user_avatar/community.openhab.org/crnjan/32/17996_2.png) [@crnjan](https://community.openhab.org/u/crnjan)\
**Post date:** [January 5, 2019, 8:41pm UTC](https://community.openhab.org/t/new-binding-rego-6xx-based-heat-pumps/17219/210 "2019-01-05T20:41:19Z")

</div>

Thanks for the feedback @cgrill75!

I haven’t got the indoor sensor so was not able to test. I will add `step=0.1` to the `indoorTempSetting` channel and I guess that will enable you to use 1/10 values within the PaperUI too.

When testing, I used something like:

```csv
Setpoint item=regoheatpump_ipRego6xx_ivt_settings_summerDisconnection minValue=10 maxValue=30 step=0.1

```

within the `.sitemap` and was able to step between all values, supported by the HP.

Regarding the `AdjustHeatCurveAtxxx` - I added those based on the mappings available from [here](http://rago600.sourceforge.net/) but never actually used/tested them - will try to check if they are mapped correctly, but again - it’s error and trial so feedback greatly appreciated 😉

---

_[View the full topic](https://community.openhab.org/t/new-binding-rego-6xx-based-heat-pumps/17219)._
