I have door sensors from Sensative which is included in my zwave network. I have installed the 2.1 version of the z-wave binding for the support for security. When opening and closing doors I get no event from the door strips but when I enable debug log I see this. Node 33 is one of the strips. 20…

[image] Martin_Larsson: Can I uninstall the 2.0 binding from paper UI You have to uninstall the old binding, also make sure you don’t have that binding configured for loading in your addons.cfg [image] Martin_Larsson: and reboot without all things and items being deleted? When switchi…

Thanks! This is the output of bundle:list right now: 195 | Active | 80 | 2.1.0.201704171736 | ZWave Binding 197 | Installed | 80 | 2.0.0 | ZWave Binding What does that tell you @sihui ? Which one is running?

It is a bit weird that two zwave bindings are listed, but because only one (the newer one) is active, I assume it is okay. Still I would do a bundle:uninstall 197 just to make sure …

[image] sihui: It is a bit weird that two zwave bindings are listed That’s not uncommon - if you have 2 bindings, then they will be listed like this - only the Active one will run. @Martin_Larsson just to say that you don’t need to use the security binding to get the Sensative strips working…

So I unistalled the 2.0 binding. Restarted openhab but still the same log when opening the door and no real event. The item does not change state. Do I need to remove the device and re-add it? @chris I need the security binding for another device. Where do I find a newer version of the binding?

@chris do you think upgrading the binging will make my stips work? There is some work involved in excluding and including devices that are mounted on doors where I drag around my RPi with ethernet and power cable. I am positive that those devices were included with the 2.1 binding build 2017041717…

No, as I said earlier, you don’t need to use the security / development binding - the strips devices work fine in the master snapshot as well.

I need the security binding for my Vision PIR sensor. So what can I do to make the strips work? Does the log tell you anything?

[image] Martin_Larsson: I need the security binding for my Vision PIR sensor. I doubt that it’s needed for a PIR sensor. It should work fine without the security - nearly all devices will work without security (except locks of course). Anyway, I misunderstood your question - yes, I would use…

No event from door sensor

Setup, Configuration and Use Beginners

chris (Chris Jackson) May 18, 2017, 5:33pm 7

If you’ve recently updated the binding, then you should try to delete the thing, and add it back again. The reason is that this will ensure that the binding is using the latest version of the thing definition. IF you don’t do this, and the things have been updated (ie the database) then they won’t take affect.

You can download it from the security thread.