There is a procedure on the device that, when performed, will blink a light a certain way if it thinks it is included in a network, and performing that task does not blink the light.
Also, I see no zwave traffic when I perform tasks on the lock that I would expect to generate traffic, like locking and unlocking with codes.
OK, I didn’t know that excluding had to start on the controller thing - the include and exclude commands on the device are the same, so I wasn’t sure how to put the device in exclude mode when it doesn’t think it’s included. I started “exclude devices” from the zwave controller thing in habmin, and performed the task on the lock, and it gave me a success code!
So after that, I deleted the node27 thing, and started discovery again. It did not pop up again immediately, so that seemed to have worked. I then included it, and it showed up as node 28 (same display as 27 showed), with habmin reporting secure inclusion failed, and another “x” failure on the lock itself.
Here’s the log from that inclusion: