Onkyo 2 Binding Commands missing

With the old version of the onkyo binding it was possible to define advanced commands like this:

Advanced commands

If you want to use commands that are not predefined by the binding you can use them with # as a prefix.

Dimmer volume { onkyo="INCREASE:hometheater:VOLUME_UP, DECREASE:hometheater:VOLUME_DOWN, *:hometheater:#MVL%02X" }

openHAB sends volume INCREASE -> binding sends VOLUME_UP (eISCP command=MVLUP)

openHAB sends volume DECREASE -> binding sends VOLUME_DOWN (eISCP command=MVLDOWN)

openHAB sends volume 30 -> binding sends eISCP command MVL1E (set volume level to 30)

Number zone4Selector { onkyo="*:hometheater:#SL4%02X" }
Switch onkyoPower { onkyo="*:hometheater:#PWR%02X" }

A list of all commands that are supported by Onkyo’s eISCP can be found here.

Is there a way in the new openhab onkyo 2 binding to define advanced commands.
I am missing the commands to change the zoom modes and audyssey settings - this was possible with the old version of the binding.

If this is not possible anymore shall i downgrade to the old binding or is there a developer who can add some advanced commands to the new binding?
Full control over the onkyo device is only possible with advanced commands like in binding version 1 or the binding developer has do define all possible commands directly in the binding - but this command list is very long - check out this document.

  • Video Wide
    • VIDEO_WIDE_AUTO
    • VIDEO_WIDE_43
    • VIDEO_WIDE_FULL
    • VIDEO_WIDE_ZOOM
    • VIDEO_WIDE_WIDEZOOM
    • VIDEO_WIDE_SMARTZOOM
    • VIDEO_WIDE_NEXT
    • VIDEO_WIDE_QUERY
  • Listen Mode
    • LISTEN_MODE_STEREO
    • LISTEN_MODE_ALCHANSTEREO
    • LISTEN_MODE_AUDYSSEY_DSX
    • LISTEN_MODE_PLII_MOVIE_DSX
    • LISTEN_MODE_PLII_MUSIC_DSX
    • LISTEN_MODE_PLII_GAME_DSX
    • LISTEN_MODE_NEO_CINEMA_DSX
    • LISTEN_MODE_NEO_MUSIC_DSX
    • LISTEN_MODE_NEURAL_SURROUND_DSX
    • LISTEN_MODE_NEURAL_DIGITAL_DSX
    • LISTEN_MODE_UP
    • LISTEN_MODE_DOWN
    • LISTEN_MODE_QUERY

Unfortunately advanced commandsa are not supported anymore.
And the is no developer working on it. :frowning: