This binding is for the Risco alarm panels.
The development/test has been performed on a LightSysPlus panel but Agility, LightSys and ProSysPlus panels should be working too.
The communication to the panel is only local via IP.
- Initial release
- Discovery, status updates, Zone bypass are working.
- Internal message handling improvement
- Preliminary support for arming and disarming
hey just tried your binding but i dont get anything in the ui but the binding is there in list
281 │ Active │ 80 │ 18.104.22.168309021036 │ openHAB Add-ons :: Bundles :: risco Binding
any chance for some documentations about it ? or do it need openhab 4.1 ?
first you have to create the “Risco Bridge” manually.
Settings → Things. Press on the + (Plus) Sign. Select the risco binding. Click on “Risco Bridge” in the “Add Manually” list.
There you are presented with the config parameters you have to enter.
- IP address of the panel
- The port (default: 1000)
- The panel id (default: 1)
- The communication password (default: 5678)
- The communication encoding (default: utf-8)
- The initial connection delay (default: 0)
Except the first setting (IP address) the rest of the settings have the default values pre-specified.
Hey thanks for the reply. Well I don’t know for the life of me why but there is no binding to select in the ui. I even clean the cache everything but your binding doesn’t show up. I think I have some knowledge about openhab but I do not find any sign of your binding except the karaf console.
But I am glad someone is actually working on this.
You need for sure openhab 4. I only tested with 4.1
That’s the reason the marketplace binding is in alpha state and not yet published…