Rollershutter Group - Display open shutters

[rossko57]

@halloween

I think, my knx is not recognizing all commands, because when there is a group command, many commands will be sent to the knx bus in very short time.

Quite possible. Use of a proxy Item and delays -

Trigger Group Item over KNX

Given these items: Rollershutter knxAllShutters {knx="..."} // or a Switch item, if you only want UP/DOWN Group:Rollershutter gShutters Rollershutter rShutter_01 (gShutters) {knx="..."} Rollershutter rShutter_02 (gShutters) {knx="..."} Rollershutter rShutter_03 (gShutters) {knx="..."} Rollershutter rShutter_04 (gShutters) {knx="..."} Rollershutter rShutter_05 (gShutters) {knx="..."} Rollershutter rShutter_06 (gShutters) {knx="..."} ... The rule would be like this: rule "drive all shutters" w…