I’ve a big problem … i can’t add devices to z-wave binding. (inclusion doesn’t work)
Raspberry Pi 3
Razberry 2 (EU)
The Z-Wave-Binding is installed.
The serial mode is configured as follow:
 1 (RPi) Disable serial console (Razberry, SCC, Enocean)
[ ] 2 (RPi3) Disable Bluetooth module (Razberry)
 3 Add common serial ports to openHAB JVM (Razberry, Enocean)
when i set the serial port to “/dev/ttyAMA0” -> the Z-Wave Serial Controller is offline
when i set the serial port to “/dev/ttyS0” -> the Z-Wave Serial Controller is online
Is that right so, with ttyS0?
with this setup, i can’t add a device (Z-Wave Cyrus Smart Home Z-Button).
i have start starting “searching for Thinks” at z-wave-binding, then the red led of razberry2
goes on (inclusion mode), pressing 3 times the button for inclusion -> it doesn’t work.
the device will not be recognized -