[SOLVED] Eurotronic Spirit Z-Wave Plus & external temperatures

[mhilbush (Mark)]

@Flynxify

The manual states that this is how you do it, I have no idea how to do that though.

Using HABmin, in the config parameters for this node, you would set config parameter 8 to 128.

However, reading this post, it appears that the binding currently doesn’t support sending the temperature to the device.

Zwave Eurotronic Spirit with external Temperatur don't work

Sorry my bad. I am confusing between sender and receiver. Actually I was referring to the Wall Sensor from Danfoss. After checking the specification, it seems that this wall thermostat does not support any associations. It just supports the lifeline group, which is for this scenario totally useless.

@chris Is this still the case?