I have almost 2 years running OH. After a crash of my RPI I thought it was time to upgrade to OH2. I’ve tried everything but I get the KNX connection not working. Sonos and Yamaha is not a problem except for KNX My openhab log tuwien.auto.calimero.exception.KNXIllegalArgumentException: non-vali…

KAi Strange but it works. My configuration is: ip=224.0.23.12 ignorelocalevents=true type=ROUTER Thanks

[image] Ferryb4: non-valid routing multicast /192.168.1.12 When using Router type, the multicast IP must be set to 224.0.23.12 like you have it now.

Hey MY KNX binding is working. When I send a value to the bus, this fine. However openhab not receive updates from the knx bus. I suspect that something is wrong with my toplogy. My configuration is as follows: Gira KNX router 216700 ip=224.0.23.12 busaddr=0.0.1 type=ROUTER localIp=192.168.1.14…

Can anyone think of an explanation of why I have no problem with the same configuration in OH1 and OH2 4 times the same value to the bus is sent? Also, the updates are not updated from the bus OH. I’m using for testing OH B4 for windows. [image]

You should try the latest SNAPSHOT rather than B4. Quite a lot of changes and enhancements have been merged.

[image] Ferryb4: Can anyone think of an explanation of why I have no problem with the same configuration in OH1 and OH2 4 times the same value to the bus is sent?Also, the updates are not updated from the bus OH. Let’s try some troubleshooting… (btw, I also recommend switching to the latest s…

Thanks for your help. I updated my openhab to the latest snapshot in Openhabian. I aslo updated my router to firmware version 3. with help of your post HowTo: GIRA KNX/IP Router . Maybe you can update these post with the TLS deactive workaround Gira.com I cannot add a IP dummy is my toplogy. Whe…

[image] Ferryb4: I don’t have any problems with the same router in OH1. I cannot explain that. This is strange.. Are you using Tunnel or Router type of connection from OH1? This means that the telegrams are crossing the GIRA Router and they reach to the openHAB (1) Host. So you don’t need t…

It seems that it is working now. I think I need a little more patience. After the initial startup KNX connection only works after 15 minutes. Thank you for your help Dimitris

openHAB Community

[Solved] OH2 KNX Binding not working

Add-ons Bindings

Kai (Kai Kreuzer) December 7, 2016, 9:43pm 2

Shouldn’t you set ip and localIp?
Fyi, I have the KNX1 binding working flawlessly on my OH2 instance.

openHAB 2 and KNX binding (no confirmation reply received for L-Data.req...)