This is the outcome of zbstatus:
20:28:04 SRC: WebConsole from 192.168.0.175
20:28:04 CMD: Group 0, Index 1, Command “ZBSTATUS”, Data “”
20:28:04 MQT: tasmota/RESULT = {“ZbStatus1”:[{“Device”:“0x8A30”}]}
And this zbconfig:
20:30:32 SRC: WebConsole from 192.168.0.165
20:30:32 CMD: Group 0, Index 1, Command “ZBCONFIG”, Data “”
20:30:32 MQT: tasmota/RESULT = {“ZbConfig”:{“Channel”:11,“PanID”:“0x3498”,“ExtPanID”:“0xCCCCCCCCE3ABF498”,“KeyL”:“0xE3ABF49826BF40A1”,“KeyH”:“0xE3ABF49826BF40A1”,“TxRadio”:20}}
Only the Sonoff Button is connected. If I enable the paring mode the following lines appear. If I reset my aqara sensor in the meantime nothing happens in the log:
31:30 CMD: ZbPermitJoin 1
20:31:30 SRC: WebConsole from 192.168.0.165
20:31:30 CMD: Group 0, Index 1, Command “ZBPERMITJOIN”, Data “1”
20:31:30 ZIG: ZbEZSPSend 22003C
20:31:30 ZIG: ZbEZSPSend 3600FCFF00003600000000000000011E0103013C01
20:31:30 MQT: tasmota/RESULT = {“ZbState”:{“Status”:21,“Message”:“Pairing mode enabled”}}
20:31:30 zigbee.permit_end_time = 1868369
20:31:30 MQT: tasmota/RESULT = {“ZbPermitJoin”:“Done”}
20:31:30 ZIG: {“ZbEZSPReceived”:“220000”}
20:31:31 ZIG: NAK, resending packet 6
20:31:31 ZIG: {“ZbEZSPReceived”:“36000029”}
20:31:31 ZIG: {“ZbEZSPReceived”:“4500050000360000000000000029FF000000FFFF03013C01”}
20:31:31 ZIG: Internal ZDO message 0x0036 sent from 0x0000 (broadcast)
20:31:31 ZIG: {“ZbEZSPReceived”:“3F0006FCFF0000360000000000000029010000”}
20:31:40 MQT: tasmota/STATE = {“Time”:“2020-12-15T20:31:40”,“Uptime”:“0T00:30:19”,“UptimeSec”:1819,“Vcc”:3.532,“Heap”:28,“SleepMode”:“Dynamic”,“Sleep”:50,“LoadAvg”:21,“MqttCount”:1,“Wifi”:{“AP”:1,“SSId”:“Flitzpiepe”,“BSSId”:“98:9B:CB:50:1D:65”,“Channel”:11,“RSSI”:76,“Signal”:-62,“LinkCount”:1,“Downtime”:“0T00:00:13”}}
20:32:30 MQT: tasmota/RESULT = {“ZbState”:{“Status”:20,“Message”:“Pairing mode disabled”}}
Are there any special configurations I have to do? In the configurations section I choose the following:
- zbbridge (75) at Configuration Module
- everything is „0“ at Configure Domoticz
- Emulation is disabled at section Other
- at Configure template I am also using Sonoff zbbridge (75)
Any suggestions? Thanks for your help.