Hi, @mgbowman after an upgrade to OH 2.5 (M5) (with a few intermediate steps in which I did not check on the bindings working) I run into an error with the Ubiquity Unifi binding. I ran a 5.7.X version of the unifi network controller until earlier today, ran into the below observed problem and up…

2.5M6 came out today Try udpadting and report in this thread: [image] 2.5 Milestone 6 Issues Installation This thread is to collect Milestone 6 issues.

[image] cmar: Unknown HTTP status code 404 returned by the controller Check your controller settings - status code 404 means it couldn’t find the API at 192.168.1.56:8443 [image] cmar: Thing client clemensPhone “Clemenss iPhone” [ mac=“AB:CD:EF:01:02:03”, contactType=“NO” ] You also n…

@mgbowman thanks for the quick reply: I got a bit further: I had the UI port for Unifi changed to 8043 to avoid conflict with an OH component but did not correct that in the config file. My bad. (suggestion: This could be a common error for people running OH and the unifi controller on the same bo…

What version of the binding are you running?

I believe it got updated automatically with my update to M6 from Karaf console list 234 │ Active │ 80 │ 2.5.0.M6 │ openHAB Add-ons :: Bundles :: UniFi Binding

I think the version in master is “case sensitive” to the clients id (this have been fixed in the latest development version). In your wirelessClient config, make sure the cid="aa:bb:cc:11:22:33" is all lower case and see if that fixes it! Matthew

I suspected as much earlier and had tried that already. All my MACS in the .things file are lowercase, but they are reported in the logs as uppercase. Here are the definitions: .things: Bridge unifi:controller:home "UniFi" [ host="192.168.1.56", port=8043, username="byname", password="XXXXXX", r…

One more thing: I reported a two crashes of M6 earlier today and removed the binding upon a suggestion of a board member. A closer look into openhab.log show 76000 lines of debug information - most of them from the unifi binding repeating the detection cycle I reported earlier over and over again in…

[image] cmar: A closer look into openhab.log show 76000 lines of debug information - most of them from the unifi binding repeating the detection cycle I reported earlier over and over again in 10 sec intervals. Naturally this only happens if you have DEBUG enabled for the UniFi binding - othe…

openHAB Community

Ubiquiti Unifi Binding throws exception

Add-ons Bindings

vzorglub (Vincent Regaud) December 1, 2019, 10:31pm 2

2.5M6 came out today
Try udpadting and report in this thread: