Hi, I have successfully Installed OpenHAB2.0 on Pi3 just by following setup guide and it’s Active, working fine. I have Sigma ACC-UZB2-U Z-Wave USB static controller & for binding it I am giving port Address as /dev/ttyACM0 under binding configuration. but all the time it is giving me communication…

[image] [SOLVED] Strange Assignment of Fibaro Double Switch 2 Bindings That should have not been necessary, during adding the stick to your setup you can choose the name freely, even to your old “thing id”. Even if you are 100% sure that the correct port is /…

Hi Sihui, Thanks for the response. I have a dought that do I need to use any USB to serial convertor or I am good with just z wave USB static controller and just need to find correct address?? Also do I need to modify any files in order to enable serial communication on USB port ??

[image] gashah143: or I am good with just z wave USB static controller Yes, that is all you need. [image] gashah143: to enable serial communication on USB port ?? That is normally not necessary, just perform the steps to connect to the zwave controller: http://docs.openhab.org/tutori…

Hi Sihui, Thanks for the help but on pi3 I am able to run only basic UI whenever I am trying to install Standard or Advanced UI it keeps on loading with message “Be standby it may take several minutes” I used to wait for more than an hour but still not getting anything. when looking at log files it…

[image] gashah143: if you are running it with Sigma stick and on pi3 can you provide me your all steps?? I followed the installation tutorial step by step, that worked for me. [image] gashah143: and while adding Sigma ACC-UBZ2-U stick it says offline. I cannot follow exactly where you…

Using Sigma ACC-UBZ2-U with OpenHAB2.0 with Raspberry Pi3

Hardware Home Automation

sihui (SiHui) October 28, 2017, 8:32am 2