Z-wave curtain found while scanning but without any channels

[Neolinger (Antonio)]

Hi Bob!
I’ve been pretty frustrated about this for the last couple of days, which is why I’m only now getting further into it.

@apella12

I believe the blog says that the Association groups and parameters need to be added manually (Not parsed from the XML). Go to the device, sign in, go to Association group tab and hit the ADD. For group 1, set the controller item to “True”. That should help get the actions on the remote controller into OH.

Have you added the Association Group yet? There’s one there now that I didn’t create.

@apella12

Still not to the part I was looking for. The end will have the “serializing NODE118 to XML” or something like that. Also note on the same site as the DB there is a log viewer option in the upper right. Run your Debug files through that. it is easier to read.

I guess I waited to long. Are the information important? Than I would exclude and re-include to get the log again.

@apella12

They did have slightly different numbers. The interesting thing is it seems to be a manual on the remote. It would be great if your contacts could provide the same information for your device remote. Another option would be to use the information from that manual to add the association groups and parameters to the ZW DB and see what works once the build is completed.

I asked the support again, but don’t get my hopes up to high.