# Z-wave: new device devolo MT:2656

**URL:** <https://community.openhab.org/t/z-wave-new-device-devolo-mt-2656/48153>\
**Category:** Installation\
**Tags:** zwave1, binding\
**Created:** [July 21, 2018, 5:37pm UTC](https://community.openhab.org/t/z-wave-new-device-devolo-mt-2656/48153 "2018-07-21T17:37:32Z")\
**Posts on this page:** 1\
**Showing post:** 25

<div class="post-metadata">

**Author:** ![5iver](https://community.openhab.org/user_avatar/community.openhab.org/5iver/32/21201_2.png) [@5iver](https://community.openhab.org/u/5iver)\
**Post date:** [August 7, 2018, 8:44pm UTC](https://community.openhab.org/t/z-wave-new-device-devolo-mt-2656/48153/25 "2018-08-07T20:44:08Z")

</div>

> [@Tuny](#):
>
> Also there are some more ‘dead nodes’ discovered. So there still might be a issue with the controller?

This is normal if you have reset the device and then included it again. You can remove them, and this way is built right into Habmin…

> [@Remove a ghost Z-Wave Node from HABmin](https://community.openhab.org/t/remove-a-ghost-z-wave-node-from-habmin/6640/24):
>
> Did you already try the “usual” way? Go to HABmin, select your node, Tools … Show advanced settings. Then click “Set device as failed”, wait a minute, then “Remove device from controller”. After that it may still be there but after an openHAB restart it should be gone.

---

_[View the full topic](https://community.openhab.org/t/z-wave-new-device-devolo-mt-2656/48153)._