Openhab 3.2 Ubuntu 20.04 on X86 [image] I have purchased several Zooz ZEN32 Scene Controllers. Great units, and I have 3 controlling Haiku fans with great success. I added one to my master bathroom to act as a regular relay for a set of sconces, and then to control scenes for various levels of…

Besides reading the above post. The log is showing three tries 5 seconds apart for the device to send a report in response to a “get” that is triggered by a “set” and then marks the device offline. The report comes through 16 seconds later, but is unknown because all the “Get”'s have been cancelle…

Thanks Stefan, I have gone through your post multiple times. Very useful, but nothing solved my issue. [image]

It looks like a communication issue to me. Meaning signal interference, or hardware issue?

Even if the device is far away from the controller, 33 seconds to respond to the first command, seems to be more device related more than radio wave problems. I haven’t deciphered the rule, but maybe the device is getting backed up (busy) with requests from prior to when your log file was created. I…

Thanks Bob, I’ll give it a shot. Since the slow downs are inconsistent (the rule runs flawlessly most of the time), I don’t think the rule is the issue, but worth a try. This morning I was reviewing logs and came across the below. Can’t quite correlate to my slow downs, but the times are close. …

Certainly could be related. Beyond my knowledge, however. Bob

I looked at the full log file. From my perspective there is a lot going on, particularly in the form of GET commands. I think @stefan.hoehn 's post goes into this. My general guideline is no polling and reports at the least frequency possible. Also I notice frequent electric readings on other de…

Thanks for taking the time to look at the log. 22 was indeed connected to a mining machine, so could have been generating lots of noise. I removed the node completely, and will continue to watch logs.

openHAB Community

ZEN32 - Slow ZWave - Offline Messages

Add-ons Bindings

stefan.hoehn (Stefan Höhn) January 20, 2022, 1:47pm 2

I have put down a lot of recommendations how to investigate zwave issue here

maybe that will help you a bit.