Zigbee home automation device "Node has not completed discovery"

Add-ons Bindings
21

Hi, have you had any success with the devices?

22

I spent quite a bit of time trying to work out the door sensor. It’s a strange device, and not a standard Develco device. It looks like it has custom firmware included - it reports the following -:

MANUFACTURER  Yoga Systems
MODEL         YOGASENSOR - HA Yoga Reed

            1    : Profile C0C9 UNKNOWN
                   -> SCENES
                   -> DEVICE_TEMPERATURE_CONFIGURATION
                   -> IDENTIFY
                   <- POWER_CONFIGURATION
            38   : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> BASIC
                   -> TEMPERATURE_MEASUREMENT
                   -> POWER_CONFIGURATION
                   <- TIME
            128  : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> BASIC
                   <- ON_OFF
            132  : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> BASIC
                   -> ANALOG_VALUE__BASIC
            144  : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> BASIC
                   -> BINARY_INPUT__BASIC
            145  : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> BASIC
                   -> BINARY_INPUT__BASIC
            160  : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> ON_OFF
                   -> BASIC
            161  : Profile 0104 ZIGBEE_HOME_AUTOMATION
                   -> ON_OFF
                   -> BASIC

This is not consistent with the Develco firmware as reported in their manuals…

I was so far unable to get this to report - I’ve been away for a few days and have literally just arrived home so will look at this again soon.

23

How did you extract this information?

24

From the device - I have software that downloads it from the device itself.

25

Hi, any breakthroughs?