Aeotec multisensor 6 and z-stick 5 NULL measurements

Setup, Configuration and Use Beginners
, ,
1

Hi, I connect the aeotec z-stick 5 and multisensor 6 in the openhab 3 but when I am creating a semantic model I can’t get any measurements. All the measurements are NULL.

Anyone with similar experience?

2

Welcome to Openhab

Likely not fully initialized. Do you have the “reinitialize device” line at the bottom of the UI page? If not, it has not been fully initialized. (Cannot reinitialize a “not fully initialized” device).
Five Lines of configured node

Need to use the wake protocol, potentially many times.

Bob