Hi, I use the following pattern to display the state of my datetimes via a stateDescription: %1$td.%1$tm.%1$tY %1$tH:%1$tM [image] The result is always 1 hour to early. As an example: 21.12.2021 14:30 instead of 21.12.2021 15:30 My locale is set like this: [image] What can be the reason th…

@rossko57 Thank you so much for helping me out again. The solution here which you linked worked for me on Synology NAS DS716+ with docker: [image] Can't get a simple time based rule to run Beginners Based on what you pointet me to: I found an article to set th…

DateTime formatter always formats and converts to local time in the GUI. So there’s two ways for it to go wrong - The “raw” Item datetime state does include timezone info, and your example is non-local; default UTC perhaps. Further, I think the formatter uses Java locale. This can be set to a di…

We seem to get a lot of these queries. I wonder if Docker installs skip setting up Java with appropriate locale. Does this need adding to some instructions, or something?

I found out at my notes that on the update from openhab 2 to 3 I did add this variable: [Docker_Umgebungsvariable Timezone] But I lost this configuration as I created a new container last month to go from 3.2.0.M5 to 3.2.0 where I didn’t copy all my configurations. For the general problem. Maybe…

DateTime format stateDescription always -1 hour

Setup, Configuration and Use Items & Sitemaps

helipus (helipus) December 22, 2021, 11:50am 3

@rossko57 Thank you so much for helping me out again.

The solution here which you linked worked for me on Synology NAS DS716+ with docker:

My configuration:

Thanks a lot!

NTP to KNX. Time is off. (after migration to 4.3?)