I don’t think this is an OpenHAB problem but I have posted my problem on other forums and haven’t found a solution. So I am hoping someone has seen this before or can suggest a forum where I can post. I have a Z-Wave door lock (914TRL Touchpad Electronic Deadbolt) that started sending phantom mess…

I believe it is securely. I used the binding and HabMIN reports, Attributes, Specific Class SPECIFIC_TYPE_SECURE_KEYPAD_DOOR_LOCK

I was a bit blurry eyed when I responded above. I see HABmin shows a green check mark for “Using Security” so I guess that means the inclusion was secure. I have been spending a lot of time going through openhab.log for this device (NODE 27). There is a lot I don’t understand with Z-Wave but I fo…

[image] PeteC: I have been spending a lot of time going through openhab.log for this device (NODE 27). @chris finds unfiltered logs are needed for troubleshooting. The log viewer should help the bleary eyes :wink: https://www.cd-jackson.com/index.php/openhab/zwave-log-viewer

Well, I started out using that but couldn’t find anything to help so I started using the viewer that has been added to http://192.168.1.115:9001/ . That is where I found s lot more NODE 27 information. Below is an unfiltered section from Chris’s log viewer. RX REQ ApplicationCommandHandler SENSOR_…

Well I have been doing a lot of experimenting with this door lock and drudging through untold openhab.logs. I wish I could find a key to deciphering the log. Anyhow, I have found that the “false” reports occur both right after a command to change and also as the result of polling which seems to hap…

[image] PeteC: Well I have been doing a lot of experimenting with this door lock and drudging through untold openhab.logs. I wish I could find a key to deciphering the log. The Z-Wave log viewer is here to help :wink: https://www.cd-jackson.com/index.php/openhab/zwave-log-viewer

I have tried to use that viewer but it seems to be missing a lot of things. I am actually comparing it to the tale right now trying to correlate the two. But I don’t see any “PEST_CONTROL” just for an example. I am trying to find a way I can ignore the polling and the first transaction after the …

I have attached a screen capture of Chris’s log. The {“type”.“25”,“value”.“1”} at time 15:22:55.665 is the one I need and it will get to the HABpanel display but then at 15:23:01.046 I get the {“type”:“22”,“value”.“0”} which overwrites the correct state. I need to find a way to detect that second …

Either you have a very small network or that is a filtered log. @chris has said many times that a filtered log is useless for troubleshooting purposes.

[image] PeteC: I need to find a way to detect that second {} and all subsequent ones (from polling) and stop them from updating the HABpanel display. These “raw” notifications are designed to be used in rules, so this is pretty easy. You need to create a virtual item - ie one that is not link…

openHAB Community

False Reports From Lock

Setup, Configuration and Use Installation

Bruce_Osborne (Bruce Osborne) August 4, 2020, 7:19pm 22

PLEASE fix that post using code fences if you wish any help.

How to use code fences - Tutorials & Examples - openHAB Community