Fibaro FGSD 002 not getting data

[jaydee73 (Stefan)]

This one:

Fibaro smoke sensor (FGSD-002) / Not getting all values from the device

Well, here is what I found out: I upated through apt-get and had to switch the mechanism to the new repository at bintray first. Before I had: 195 | Active | 80 | 2.0.0.201701071314 | ZWave Binding And after the update/upgrade: 195 | Active | 80 | 2.0.0.201701071702 | ZWave Binding So only a slighty newer build. But gladly your changes were implemented in the newer build (at least I think so). Initialisation went well and I also got the xml files soon afterwards. I got a wakeup…

You should:

• delete the thing and the node xml (only if the device was fully initialized. Otherwise I would suggest to exclude it again and also delete all shadows in the controller, followed by a reset of the device)
• update/upgrade your installation to get the latest zwave binding (yours is from 2017/01/03 and the probably necessary changes in the binding were on 2017/01/09 (be aware of the latest changes in the repository structure yesterday!))
• check if you have the latest binding (log into the karaf console and type bundle:list to get a full list of all installed packages).
• re-add the device (or include it again, based on what you did above). Check the configuration parameters. Do update/change them if necessary. Wake it up 2-3 times (for me 2 times were enough) and see if the xml was created.