FIbaro motion sensors only reporting ALARM class

[chris (Chris Jackson)]

This is the previous discussion this afternoon - I suspect it’s the same sensor as you have -:

Zwave plus

I Set 20… but was not updated… I try, I have to umount from door for press three time the button … For Chris,This is the parameter suggested by Spaceman 7: Customer Function 4 Parameter to set the Customer Function. Bit 0: Reserved. Bit 1: Enable sending motion OFF report. 0: Disable, 1: Enable. Note: Depends on the Bit4, 0: Report Notification CC, Type: 0x07, Event: 0xFE 1: Sensor Binary Report, 20 --> set the bit 4

Take a look at that thread and see if it solves the issue.