We agree on baby steps. My concern is the device is NOT in the ZW DB. If that is true, everything done so far was a (painful?) learning experience. Devices are recognized by the numbers (in hex), not the model information and I copied the node x message directly from the docs. It is also on your screen shot under the orange bar. Numbers might be covered up by the orange bar. This post is background. I want to confirm the numbers before doing anything else.
One thing to try to get these numbers (since I do not see them in your screenshot). On OH5 with the 10 Pro, put the ZW binding in Debug mode (UI setting page on the right), then put the controller in exclude mode from it’s UI page and press the EXCLUDE sequence from the lock manual. If the log shows that was a success, then go to inbox, zwave, scan while pressing the INCLUDE sequence from the manual. There should be the needed numbers in the debug log
