Hi, since upgrading to OH3.2 from 3.1 I am struggling to get my Reolink 511WA to work. It was working pretty well under 3.1 (the below issue would come up very, very rarely), but with OH3.2 the camera is not working most of the time.
I have set up the camera with an Onvif profile, port 8000. As I said, that was all working well enough with OH3.1. I have linked only a few channels to items, mainly the ones relating to alarms / motion detection, none related to getting images, video, etc.
Ever since upgrading to OH3.2 I am getting the below warning every few hours, and then usually four times within a minute:
2022-01-07 16:48:18.726 [WARN ] [amera.internal.onvif.OnvifConnection] - Binding could not determin the cameras current PTZ location. Not all cameras respond to GetStatus requests.
Also, most of the time now the items stop functioning, ie motion alarms do not arrive in OH anymore, although there have been episodes where they have been working again for a couple of hours. Could not make out what was different, though.
There were no obvious configuration errors in the camera thing, so I tried deleting the thing and then re-adding it (the scan function did not find the camera, so I had to add manually as an Onvif camera). That did not fix the issue, though, the above warning popped up afterwards again.
Looking at the thing / items a bit closer, I see that all the alarm items, including the ones that used to work previously (eg LastMotionType and CellMotionAlarm) remain NULL, despite alarms being registered by the camera. On the other hand, just for testing I activated the Url items, and they do receive proper values.
Not sure whether that is relevant, but I also have the camera connected to Synology Surveillance Station, and there all alarms are registered well and recordings are created.
I am a bit at a loss now and would very much appreciate any ideas or pointers on how to get this going again…