New to Openhab looking for info on reverse engineering?

[Michilson]

Hello guys,

I am new to this site, Program. I am looking into what products will work with Openhab2 and I found some Wifi Switches. My question is how would you suggest going about reverse engineering them to figure out weather OpenHab2 can control them or not?

I’m wondering if you can re-flash them with your own code to have wifi HTTP access does anyone have any input on this? Or is there a switch shell that we can buy and DIY our own switchs using the ESP8266 as the work horse?

Thanks

[Dim]

My question is how would you suggest going about reverse engineering them to figure out weather OpenHab2 can control them or not?

What kind of communications do they support out of the box?
If they can be controlled remotely using http and/or mqtt, then you can use the respective bindings and integrate them in your OH2 installation.

Or is there a switch shell that we can buy and DIY our own switchs using the ESP8266 as the work horse?

You mean something like:

ITEAD Sonoff switches and sockets - cheap ESP8266 Wifi+MQTT hardware

ITEAD Smart Home Products https://www.itead.cc/wiki/Sonoff_Smart_Home_Solution [image][image][image] These very cheap modules come with their special smartphone app but are all actually based on the famous ESP8266. It didn’t take long till the tinkerer community got a hold of that and started hacking. After opening up the cases, all you need to do is solder a few header pins and connect your FTDI breakout programmer. Alternative firmwares are ready to provide nice MQTT based Wifi SmartHome end…

[Michilson]

Yes but I’m still looking for the Wall switch tactile feel and look. I’ve thought about making my own circuit board using high volt relay to drive light power step down 110 to 5 v and use a standard switch as input sorce on the ESP8266.

What kind of communications do they support out of the box?

If they can be controlled remotely using http and/or mqtt, then you can use the respective bindings and integrate them in your OH2 installation.

Ankuoo NEO Wi-Fi Light Switch (older Version uses Android app)

Amazon.com: Ankuoo NEO Wi-Fi Light Switch, NOT Plug & Play, Limited DIY Required, White: Home Improvement

Ankuoo REC Wi-Fi Light Switch (Newer Version reported to be open API)

Amazon.com: Ankuoo REC Wi-Fi Light Switch with Push Notification, Works with Alexa, New Firmware with AP Mode, NOT Plug & Play, Limited DIY Required, White: Home Improvement

I’m looking for a more cost effective device than a TP-Link of a WEMo unit.