Oh-label-card trigger three actions / change three items

[mitch (Mitchell)]

Good morning from New Zealand. Winter here so Openhab configuring session

Trying to setup a panel for controlling my heatpump via echonet lite. Have the basic’s working but was wondering if the following is possible:

• Using a oh-label-card, is it possible on selection to trigger two or more actions?
• What I want to happen is on the selection of the ‘Heating’ label I want three actions commands for the following items: Heatpump_Opearation_Status = ON, Heatpump_Opearation_Mode = Heating, Heatpump_Tempature_Set = 24

I could do this via a rule, but wondering if it’s possible to have an expression in the Label’s ‘actionCommand’ that allows for multiple actions?

[JustinG]

In this case I would recommend a rule, but there is a non-rule solution:

Multiple Widget Actions

Since the beginning of MainUI this question has cropped up with some regularity: Can I trigger more than one of the OH widget actions on a component with a single click? The answer has always, rightly, been: No, you can only define a single action for each component in a widget. This answer is not 100% true, there are ugly hacks that could allow a click on a link, for example, to trigger the actions of other components, but these are not truly supported nor even advised. The question (and def…

[mitch (Mitchell)]

Thanks for the link! Think my searching was too specific to label widgets when this applies to all widgets. Rule it is.