siod
(John Doe)
December 29, 2020, 6:19pm
1
Hi,
can anyone give me an example on how to add a wireless wall plug MQTT item in OH3? None of my MQTT devices is autodiscovered (bridge is shown as online, so that should work…) and I don´t get how to set up a MQTT item which I can control remotely using MQTT over OH3.
Thanks in advance!
Foreword
This tutorial is for openHAB3. If you are on openHAB2 you will need to use my older tutorial .
This tutorial was written with openHAB3 running on a headless Raspberry Pi 3B with Raspberry Pi OS, with SSH access.
Overview
This tutorial assumes you have openHAB3 installed.
This tutorial will show you how to:
Install an MQTT broker, install the MQTT binding, and connect the two
Setup device to read the DHT22 temperature sensor
Setup device to connect to the MQTT broker
Configure openHA…
This is for a Tasmota flashed relay, but the openHAB stuff is the same (save for the exact topics, of course - only you know those!)
1 Like
siod
(John Doe)
December 29, 2020, 6:37pm
3
great, exactly what I was looking for and I could already realize it!