I’m not able to integrate the Osram Smart+ Switch Mini into openHAB.
I’m able to pair the switch directly to one single light bulb and control the bulb that way (but that’s obviously not what I want).
When activating pairing mode for my Ember ZigBee USB-Stick and activating pairing mode on the switch (holding up and down together), while holding both near eachother, the switch doesn’t show up in PaperUI.
I just got one of these switches today. I have OH3 running on a rPi with a Bitron Video USB dongle. I was able to add the Osram Smart+ wall sockets with no issues, but this wireless switch remote gets added as a generic zigbee device with no channels. In my list of things it shows offline (which I guess is right since it’s a wireless remote?) and says Node has not completed discovery. When I put it in pairing mode (o + /) the blue light flashes continuously until OH discovers it then shuts off immediately, like it’s not finishing the initial discovery handshake.
2021-01-22 15:22:39.532 [INFO ] [openhab.event.InboxAddedEvent ] - Discovery Result with UID ‘zigbee:device:013724B2:000d6f00123a47f4’ has been added.
2021-01-22 15:23:16.612 [INFO ] [openhab.event.InboxRemovedEvent ] - Discovery Result with UID ‘zigbee:device:013724B2:000d6f00123a47f4’ has been removed.
2021-01-22 15:23:16.636 [INFO ] [ab.event.ThingStatusInfoChangedEvent] - Thing ‘zigbee:device:013724B2:000d6f00123a47f4’ changed from UNINITIALIZED to INITIALIZING
2021-01-22 15:23:16.657 [INFO ] [ab.event.ThingStatusInfoChangedEvent] - Thing ‘zigbee:device:013724B2:000d6f00123a47f4’ changed from INITIALIZING to UNKNOWN
2021-01-22 15:23:16.671 [INFO ] [ab.event.ThingStatusInfoChangedEvent] - Thing ‘zigbee:device:013724B2:000d6f00123a47f4’ changed from UNKNOWN to OFFLINE: Node has not completed discovery
2021-01-22 15:23:17.201 [INFO ] [penhab.event.FirmwareStatusInfoEvent] - Firmware status of thing zigbee:device:013724B2:000d6f00123a47f4 changed to UNKNOWN.
I personally never got to the point where the “Switch Mini” is discovered.
I refunded it a few days ago and will try different switches in the future …
I hope, someone has an advice for your problem (@Unclfuzzy) …