RGB LED strip control using Arduino and MQTT

kluszczyn · January 20, 2018, 9:03am

Please check sonoff-tasmota, it’s supporting lot of things beside sonoff devices, details in

arendst/Sonoff-Tasmota/blob/development/README.md

## Sonoff-Tasmota
Provide ESP8266 based Sonoff by [iTead Studio](https://www.itead.cc/) and ElectroDragon IoT Relay with Serial, Web and MQTT control allowing 'Over the Air' or OTA firmware updates using Arduino IDE.

Current version is **5.12.0b** - See [sonoff/_releasenotes.ino](https://github.com/arendst/Sonoff-Tasmota/blob/development/sonoff/_releasenotes.ino) for change information.

### ATTENTION All versions

Only Flash Mode DOUT is supported. Do not use Flash Mode DIO / QIO / QOUT as it might seem to brick your device.

See [Wiki](https://github.com/arendst/Sonoff-Tasmota/wiki/Theo's-Tasmota-Tips) for background information.

### ATTENTION Version 5 and up

These versions use a new linker script to free flash memory for future code additions. It moves the settings from Spiffs to Eeprom. If you compile your own firmware download the new linker to your IDE or Platformio base folder. See [Wiki > Prerequisite](https://github.com/arendst/Sonoff-Tasmota/wiki/Prerequisite).

Best practice to implement is:
- Open the webpage to your device
- Perform option ``Backup Configuration``
- Upgrade new firmware using ``Firmware upgrade``
- If configuration conversion fails keep the webpage open and perform ``Restore Configuration``

This file has been truncated. show original

I was using this firmware together with MagicHome and on bare esp12 modules. Works great!