======================================= my_sysinfo - Start ======================================================== ******* Hardware-Info = model name : ARMv7 Processor rev 3 (v7l) ******* Hardware-Info = model name : ARMv7 Processor rev 3 (v7l) ******* Hardware-Info = model …

This does not look to be in any way related to scripted automation or Jython and appears to be a network or power management issue. Turning on debugging for the Homematic and AVM add-ons might shed some more light. Although, it looks like your Samsung TV binding also dropped offline and OHC had a hi…

Did you reboot at 12:20, or is it just having a general meltdown?

Hi Scott, thx for answering. So first I have to ask what is “OHC”, second, where do I find the system log and what IP-Adress could be meant ? I have not running both OH-Systems beside each other. I t shut down now the Jython-System and running the “normal” openHAB-System, which is the same Setup. …

Hi, at 12:20 I stopped OH (sudo systemctl stop openhab2). After that I made reboot but after some hours - same problem. So then I stopped Jython-System and started “normal” System again, which runs now since 19:08. So I don’t know where to look, as in the past my Jython-System with a Minimal-Setup…

[image] fibu-freak: So first I have to ask what is “OHC” openHAB Core… but this would have been due to to your manual shutdown. [image] fibu-freak: where do I find the system log Raspian comes with systemd, so you could use journalctl. However, I do not have any experience with Raspbe…

[image] 5iver: openHAB Core… …sorry for my ignorance :innocent: :sweat_smile: [image] 5iver: so you could use journalctl I will test this, thx for the hint. (I found a lot of log-files under /var/log) [image] 5iver: Is this the same as was used on the other system, and are they b…

I don’t think. When Jython-openHAB is online, the other openHAB is stopped and disabled.

openHAB Community

Scripted Automation OH loses Thing Connections OH-Version 2.5.9

Setup, Configuration and Use Beginners

rossko57 (Rossko57) October 1, 2020, 12:26pm 8

Do the AVM and Homematic targets support talking to more than one other system at a time?