Sebson GS559A Smoke Detector with nanoCUL USB Stick FTDI CC1101 868MHz

Setup, Configuration and Use Beginners
, ,
1

Hello Everyone,

I’m new to openHAB and would like to ask a question.

Does anybody know if it’s possible to use openHAB(ian) 3 on a Raspberry Pi 3 to monitor the 868 mhz smokedetector GS559A from Sebson with a nanoCUL usb stick FTDI CC1101 868MHz firmware 1.67?

I read that it’s possible with this cul usb stick but with other manufacturers than Sebson. But basically it should be possible right?

And of course I want to use openHAB(ian). So maybe anybody here who has some experience with that combination or similiar?

Thank you very yery much in advance.

Best regards, Chris