I am trying to set up zigbee devices through a bridge. I flashed the Sonoff bridge to tasmota, and can control devices through the console (although it needs the hex name - it gives and error using friendly names) zbsend{“device”:“0xA123”, “send”:{“power”:“on”}} works; using “device”:“zigbeePlug” …

SO, I have it mostly working. The switches operate and the leak sensor sends alerts. I am still working on getting devices to report status - things like reachable and battery level - but at least I have basic functionality. Here is my code, such as it is: tasmota.things: Thing mqtt:topic:Zigbe…

can you show the output from the tasmota console [image] alaskamike: zbsend{“device”:“0xA123”, “send”:{“power”:“on”}} works;

I think I have a problem in my files - the command is not being sent to mqtt. mqqt.things (connection to the MQTT server) Bridge mqtt:broker:MosquittoMqttBroker "Mosquitto MQTT Broker" [ host="192.168.0.14", secure=false, port=1883, username="openhabian", ] tasmota.things (the plug) Thing m…

[image] alaskamike: No messages are being sent to mqtt What tool are you using to verify this? If you’re not already, please install MQTT Explorer and use that to watch all the incoming messages to your MQTT broker. Does your MQTT broker have a username and password? Please also review the …

Your screeshot say that tasmotaHub is the Topic [image] alaskamike: [Screenshot from 2022-12-08 17-11-15] Screenshot from 2022-12-08 17-11-15496×881 44.5 KB but in your thing zPlug1 is your topic, this can`t work [image] Rolli: can you show the output from the tasmota console [im…

TasmotaHub is what I thought was the name of the bridge. Should that field be empty?

Thanks for the tutorial - it’s where I started! I think what confuses me is that I have a bridge rather than a flashed device (I flashed the bridge but the plug still uses zigbee. I just redid everything per your tutorial, and from what I can see, openhab is not sending any commands to mqtt (altho…

You still use the wrong topic. Why not just post the output of your tasmota cosole, i asked twice already.

Here’s the console output. Thanks for the help. 18:23:56.578 ZIG: {"ZbZCLReceived":{"groupid":0,"clusterid":"0x0006","srcaddr":"0x8BAD","srcendpoint":1,"dstendpoint":1,"wasbroadcast":0,"LinkQuality":71,"securityuse":0,"seqnumber":203,"fc":"0x18","frametype":0,"direction":1,"disableresp":1,"manuf":…

type in your tasmota console Setoption89 1 restart the device and post the same output as above again

Setting up zigbee devices witha tasmota bridge

Setup, Configuration and Use Beginners

hafniumzinc (T) December 11, 2022, 12:39pm 26

May I recommend the following tutorial - it should help you with the basics of getting Tasmota devices into openHAB via MQTT - there’s quite a few parts which need correctly configuring, and the tutorial goes into some depth to try and help.