Using openHABian on a Raspberry Pi 2. Used the lasted image from OpenHAB, also used Etcher to flash the card. The card was also formatted before flashing. I am able to access the openHAB initial setup page just fine and can install whatever add-ons and use Paper-UI. I had the same issue error, b…

[image] SCADA_Boi: I am using is a CanaKit 2.5A for my Raspberry Pi 2 CanaKit makes good stuff so the power shouldn’t be an issue but you may still want to verify with a meter if you have one. Even the good stuff will eventually go bad. A new SD sounds good. :+1: Be sure to make a backup of …

Hopefully all keeps running smooth for you :smile:, but if not, there are multiple possible reasons for your issue, including hardware issues… Freezes and other ‘random’ behaviour often point in the direction of SD card or power supply issues. They can be very obvious (“it doesn’t work”) or very vag…

You said you formatted the SD card first. Did you use the sd card formatter program recommended by Raspberry Pi? I have sometimes seen that fix card issues. You could have just installed OpenHABian on Raspian by following the Linux installation instructions. The image is basically Raspian Lite anyw…

[image] SCADA_Boi: used Etcher to flash the card. I’ve never needed to format first when using Etcher so try a different SD card or try to install Noobs or Rasbian lite on the Pi. If nothing installs then it’s either the card, Pi, or PC used for flashing.

[image] H102: I’ve never needed to format first when using Etcher so try a different SD card or try to install Noobs or Rasbian lite on the Pi. I figured those that made the Pi and customized Debian to make Raspbian had a good reason to say you needed to use the formatting application. In my…

I am using is a CanaKit 2.5A for my Raspberry Pi 2. The card I am using most likely has been used for quite awhile with various school projects. I will replace the SD card and see where that gets me.

Got a new SD with new image flashed onto it. I am now using a Raspberry Pi 3B+… So far everything is a go.. I have none of the errors from before. Thanks all for the suggestions!!!

[image] SCADA_Boi: So far everything is a go… I have none of the errors from before. Thanks all for the suggestions!!! Glad you have it working. :+1: Usually, the main problem is either the power supply or the SD card. Most that commented have seen this issue multiple times here on the forum…

openHAB Community

[SOLVED] Compatibility Issues: systemd[1]: Failed to start /etc/rc.local Compatibility

Setup, Configuration and Use Installation

mstormi (Markus Storm) February 4, 2020, 6:38am 10

Consider enabling ZRAM to avoid have it happen again.