[SOLVED] GoControl NGD00Z-4 Garage Door Controller Configuration

[sihui]

Welcome!

Please check this post_

OpenHab2 and Linear NGD00Z-4 Garage Door Controller

The barrier_state channel should be linked to a Number Item, and will report: 255 (open) 254 (opening) 253 (stopped) 252 (closing) 0 (closed) It is also used to control the garage door, by sending 255 (open) and 0 (close). You should setup a Switch Item that you can set to ON or OFF through a rule, based on the barrier_state, and to control the door. I have two NGD00Zs, and this is an example of how I used them in the Rules DSL… I haven’t looked at this for a while, as I now use JSR223-Jyth…

@Derekj

easy and complete guide to help someone else in the future get this device going with their openHAB2 installation