Hi Thomas.
There is an OH3 milestone build which contains all the OH 2.5 bindings recompiled. You can find the post here: https://community.openhab.org/t/openhab-3-milestone-builds/106329
I thought of testing it.
Anyway I’m testing your binding in a special setup where I made a dedicated LAN connection between my Windows server and the gateway and turned off any adapter bindings on this NIC only IP4 left on. I specified a separated subnet for the server (192.168.10.1) and the gateway (192.168.10.2) – my LAN is on 192.168.1.1/24 and there is no routing between them. Openhab is installed on this server. I specified this IP (192.168.10.1) for the gateway in your binding. I don’t want to be positive too early but it seems that it is so far so good and there is no errors in the logs.
Before this I set up the gateway and the app by wire following its manual and after that I made a WLAN connection within the Bisecur App. Then I opened the web interface and changed the LAN IP to the above I mentioned (DHCP is turned off for LAN and turned on for WLAN). I think this might be a supposed solution if the binding goes online within openhab-addons. I wiresharked the connection and there were some TCP connection reset while LAN DHCP was left on (every 3 minutes) but after turning DHCP off resets went away and now I have only a few errors of: “Received Exception Receiver got signal to stop -> stopping receiving activities => retrying…”
So I’m pleased with this solution and hope it will work in OH3 as well. All these are based on the last 24 hours of testing so it needs to be observed further. I’ll report back in case of any issues…
Thank you,
Zsolt.