"Thing Properties" of Aeotec Z-Stick Gen5+ in PaperUI not shown (Openhabian)

Setup, Configuration and Use Installation
1
  • Platform information:
    • Raspberry Pi 4 B 4GB
    • OpenHAB 3.2 (Openhabian)
      After a clean install with the latest Openhabian I have some issues with the Aeotec Z-Stick Gen5+. The controller works and z-wave devices are connecting and fully functional. Unfortunattely the controller properties are not shown in the PaperUI under the -Information- header. There should be displayed “Thing Type” and “Thing Properties”.The latter is missing and should show “zwave_nodeid” and “zwave_neighbours” as well.

image
image1118×459 13.7 KB

It should look like this:

image
image1529×549 16.8 KB

In the “z-wave network map” node01 is missing (controller) and the other zwave nodes are visible but without any connection lines:

image
image795×442 2.87 KB

Could there maybe be a relation between the wrong initialisation and the incomplete network map ? All suggestions and workarrounds are welcome.

2

Hi, it works now. When the Z-wave Network Heal “Heal Time” expires both -Thing Properties - and the connection lines are visible. Somehow it takes some time (hours not minutes) after the time set in this field expires.