Hi all, I have been trying to rewrite the openhab2 documentation with a tutorial with how to setup NGINX with use for openHAB2, I see a lot of questions about authentication and HTTPS and I feel these are the steps that would make it easier for people. I’m looking for any type of feedback and quest…

I’ve corrected both ssl and Nginx confs as you wrote - still ssl error in log viewer and graphana port 3000 I’ve corrected also my above post to be in line with my files and reload cert in Windows.

You are not proxying port 9001 I believe log viewer does http on port 9001, not https http is not ssl so there would be an ssl error. For my nginx reverse proxy I proxied 9001 too. I assume the same holds true with Grafana.

Can you post your nginx conf with 9001 port - just as an example how to add additional port. shall I add whole patr called ## Reverse Proxy to openHAB with different port in location?

I actually proxy 9001 to 9002 and edited the dashboard, if I recall correctly. Here is the redacted configuration. I also require authentication for the log viewer since I have exposed this over the Internet for remote access. server { listen 9002 ssl; ser…

Hi all, stupid question… but how can I access to the nginx config file? In the tutorial it says the file is located at: /etc/nginx/sites-enabled/default But where is this folder and how can I get access to it? Thank you very much!

[image] GigaTronic: In the tutorial it says the file is located at: /etc/nginx/sites-enabled/default No, it says: [image] Benjy: The location of the default setup is /etc/nginx/sites-enabled/default . To allow NGINX to proxy openHAB, you need to change this file So it says file, not f…

[image] GigaTronic: But where is this folder and how can I get access to it? It is where you stated and is accessible by ssh.

[image] GigaTronic: But where is this folder and how can I get access to it? Log into the machine running nginx and cd to that folder.

Thank you all I have installed OH 2.5.0-1 on a raspberry pi. I have connected with PUTTY on my machine and was able to type in this command: cd /etc/nginx/sites-enabled/ → [20:09:27] openhabian@openhab:/etc/nginx/sites-enabled$ But what now? How can I open the file and edit it? Sorry.. I am a…