(Z-Wave) Fibaro FGMS-001 Motion Sensor problems

Hi to the forum,
I included two “Fibaro FGMS-001 Motion Sensor” successfully (they were discovered and identified correctly) but they do not send notifications about motion detection, illumination or seismic vibrations - all linked items remain NULL even after days of operation.
I assossiated “Assossiation 2: Motion” and the other to the Z-Wave controller, but nothing happens.
Can someone tell me what’s going wrong here?

Regards from Germany

Ansgar

Possibly not fully discovered. If you go to thing, very bottom, just above delete thing, are there 5 lines? Particularly reinitialize device? If no need to wake until that appears.

Also group 2 is only to send a basic set in the event of motion. Like to turn on light.

Thanks apella12,
that was the problem. Now it works fine :slight_smile: