ZigBee network map when using only the ZigBee Binding

Hi all,

now i just have the following issue:

the script runs unless this is displayed:

Trying to find neighbors for Zigbee device with network Address: 54752
Found: 27 neighbors
Trying to find neighbors for Zigbee device with network Address: 57383
Found: 27 neighbors
Trying to find neighbors for Zigbee device with network Address: 60740
Found: 28 neighbors
Trying to find neighbors for Zigbee device with network Address: 61538
Found: 21 neighbors

But then the “dot” process takes 100% CPU at the moment for 14 minutes.
Anyone has an idea why?


top - 11:10:18 up 16:07,  2 users,  load average: 1.01, 1.08, 0.91
Tasks: 186 total,   2 running, 184 sleeping,   0 stopped,   0 zombie
%Cpu(s): 26.5 us,  1.1 sy,  0.0 ni, 72.4 id,  0.0 wa,  0.0 hi,  0.0 si,  0.0 st
MiB Mem :   7821.9 total,   2851.0 free,   2052.0 used,   3024.9 buff/cache
MiB Swap:    200.0 total,    200.0 free,      0.0 used.   5769.8 avail Mem

    PID USER      PR  NI    VIRT    RES    SHR S  %CPU  %MEM     TIME+ COMMAND
 294592 frsc      20   0  176040  16256  11008 R  99.7   0.2  14:07.48 dot