Adding Z wave Node

[Jorgen_Lovseth (Jørgen Løvseth)]

Hello
I finally got it to work! And the node now comes up as it should, and I can control my light using the paper UI.

Next up is to configure the Dimming node to one of the channels on på In-wall sitch(2channel).

I`ve been reading some aboout it and found this:

ZWave Manual Thing Configuration

This write-up provides a “how-to” to actually get this configuration completed for Z-Wave for those that don’t want to use the automatic configuration that the binding provides. Z-Wave things can be configured in the same way as other OH2 bindings - for general information refer to the OH2 documentation. Note that at the time of writing, text configuration of things is only available in the development version of the binding - not the master or snapshot versions. At the time of writing, there …

Is this something I can do in the OH2 Paper UI, or is this only through the xml file?

If it is through the xml file, do I just write the commands(in the link, ofc with my node ID etc) and just save the file in the userdata folder?

Regards
Jørgen